Question: In Lab , I have used two Cisco WS-C3560X-24T-L Switches. I have created two vlans Vlan2 and Vlan 3 on first Switch. I have created two SVI on first switch and assign Ip address 10.10.20.1/24 and 10.10.30.1/24 respectively. Host between...
Question: Why would we configure secondary ip on an interface Suggestions please Answer: With secondary addressing, multiple IP subnets coexist in the same LAN. It's a handy tool for non-disruptively adding IP addresses to an existing LAN, without...
Question; If the connecting port on WS-C3750X-48T-L to procurve 2910 belongs vlan 10, does the connecting port on procurve 2910 has to belong to the same vlan? Would both switches be connected if their connecting ports do not have the same vlan number?...
Question: So the problem is we have a device or host that needs to communicate on a specific VLAN. This VLAN is not new, it is running all throughout our environment and works fine. But the VLAN was recently configured on the switch in question, a Cisco...
We have just recently cut over from an older core switch/router platform (running CatOS 8.x) to a newer platform running IOS 15. So all the SVI's for our VLANs moved over from the old platform to the new, and a trunk link (4x1GB etherchannel) was configured...
When configuring a cisco router or switch, you may have been told that you can stop your console or telnet sessions from timing out by using the following configuration: line con 0 !(or line vty 0 4) no exec-timeout !DON'T DO THIS! NEVER issue the command...
This question was discussed recently on the Cisco CCIE Routing and Switching Study Group website. It took me years to work out that the problem with this question is the question itself, not the answer. The question gives the impression that “Hybrid“...
Whats the difference between copy running-config startup-config and Write Memory On a Cisco Switch or Router? What cisco ios command would you use to find out the value of the config register on a cisco router? As most things on IOS, show is the way to...
I eventually solved a perplexing problem setting up telnet for a new switch. I installed a new Cisco WS-3560X-24P-S switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking, I could not telnet...
Question: I have a small doubt. Locally generated traffic and traffic destined to local interface should be process switched on a router as per my knowledge (I might be wrong though). R1 ----------Serial Link----------------R2 s1/0 s1/0 Please check above...
